Frequently asked questions about Albert little

How can I connect the drainage hose with Albert little?

If desired, it is possible to connect the drainage hose to Albert little for permanent water drainage without removing the water tank (see picture 1). In this case, connect the hose to the unit through the hole in the back of Albert little (see picture 2). Place the other end of the drainage hose in a water outlet. Please make sure the end of the hose is lower than the spout, otherwise the water will not drain and flooding may occur.

Yes, it has a memory of 24 hours and switches back on after the power supply is interrupted.

Unfortunately, this is a technical defect. Please return your Albert little to the retailer shop where you purchased it. Your Albert needs to be repaired.

Please make sure the settings of your device are as per the operating instructions. The desired level of humidity may have already been reached. If this is not the case and Albert little still does not dehumidify, return it to the retailer shop where you purchased it.

When the blinking symbol appears on the display, it means that the desired humidity has been reached and Albert little will then switch himself off automatically.

You can set the desired humidity by pressing the knob hygrostat and using the rotary control to select the desired target humidity. Alternatively, the dehumidifier can be set to continuous running.

Yes, your settings will be saved. If Albert little is switched off and then on again, the most recent settings used will be applied.

Is the answer to your problem missing? Please enter your question below and we will contact you.

* Mandatory fields

HappyToHelp