Lucy

We recommend the use of pure natural essential oils for the operation of your aroma diffuser.

To begin with, you can add 2-3 drops of the scented oil to the water. Depending on the desired intensity of the fragrance, you can increase or decrease the number of drops. 

If you barely smell the scent, please look at the list with recommendations:

• Make sure the aroma diffuser is positioned where you like the scent to be most noticeable, best at least 70 cm above the floor.
• Increase the amount of oil/fragrance drops in the diffuser.
• Try different kind of fragrances/essential oils.
• How much the scent is noticeable depends mostly on the quality of the fragrance itself (synthetic, natural, ingredients, etc.). It is comparable with wine; quality is everything plus the scent also changes over time. Our experience is that the best results are achieved with 100% pure essential oils of a high quality and concentration.
• The room temperature and relative air humidity influence how noticeable the scent is. The drier the environment, the less noticeable is the scent.
• A high rate of air ventilation (opening windows and/or heating/air conditioning) has a direct influence on the scent because it makes it disappear faster. Reducing the air ventilation and not putting the aroma diffuser next to an air vent helps to increase the time the scent remains in the air and thus the noticeability. This also means no tilted windows.
• Clean the inside of the aroma diffuser at least once a week and make sure to thoroughly clean the transducer from any oil/scent residues. The transducer can be clogged which results in a lower output and less noticeability of the scent.

Make sure that the LED dimmer is deactivated (press the right-hand button on the front several times: normal – dimmed – switched off).

If there are limescale deposits on the membrane, Lucy’s mist may be less distinct or less powerful. If that is the case, you can clean and descale your Lucy thoroughly, paying particular attention to the membrane. We recommend wiping the membrane carefully with a cotton bud soaked in descaler until all the limescale has gone. Under no circumstances should you attempt to chip limescale deposits off the membrane using a hard or pointed object!

After cleaning, rinse thoroughly with clean water.
Make sure that no water gets into the air outlet opening during cleaning or rinsing.

Yes, Lucy has a battery with a running time of up to 7 hours. The battery must be fully charged for at least 6 hours before using it for the first time.  

As soon as the LED on the back starts flashing, Lucy must be recharged. We recommend that you don’t use the aroma diffuser while it is charging so that the battery can be fully charged as quickly as possible.

Yes, the device will switch off automatically when there is no water left in the water container. Lucy will not be damaged if she runs out of water.

1. Unplug Lucy
2. Empty Lucy's  water tank and rinse it out with warm water
3. Plug Lucy back in again
4. Press and hold down the LED button first and then also press the ON/OFF button
5. Hold down both buttons for approximately 2-3 seconds
6. After that, the LED should flash 4 times
7. Refill Lucy with water and switch her on again

We do not recommend you to use Lucy with distilled water. 

You can clean the water container using a common household descaler. Mix the descaler with water according to the instructions on the packaging. Please do not attempt to chip limescale deposits off the membrane using a hard object. In the case of stubborn limescale deposits, we recommend repeating the descaling process several times in a row. Make sure that no water gets into the air outlet opening. After descaling, carefully rinse out the base and dry it thoroughly. Clean the top part regularly using a damp cloth.